In the previous nonlinear leaf spring tutorial (part 2), I have mentioned that there are ways to optimize the E_N penetration contact coefficient. This is a procedure which is usually done recursively by choosing a coefficient, checking the penetration and then increasing the value until a good solution is obtained. In Code_Aster, there is a […]
[Salome Meca Tutorial] Leaf Spring Nonlinear Material and Contact FEA Simulation – Part 2
![[Salome Meca Tutorial] Leaf Spring Nonlinear Material and Contact FEA Simulation – Part 2](https://feaforall.com/wp-content/uploads/2021/12/spring-tuto-part-2-tuto-1024x576.jpg)
In this Salome Meca Tutorial, we will go through one of the most complex simulation on this channel, a leaf spring simulation with 3 distinct types of nonlinearity: Nonlinear Material, Large displacements and Nonlinear contact ! I chose to divide this tutorial in 2 parts because it is a very complex simulation and there are […]
[Salome Meca Tutorial] Leaf Spring Nonlinear Material and Contact FEA Simulation – Part 1
![[Salome Meca Tutorial] Leaf Spring Nonlinear Material and Contact FEA Simulation – Part 1](https://feaforall.com/wp-content/uploads/2021/11/leaf-spring-tutorial-part-1-thumbnail-1024x576.jpg)
In this Salome Meca Tutorial, we will go through one of the most complex simulation on this channel, a leaf spring simulation with 3 types of nonlinearity!
[Salome Meca Tutorial] How to simulate a contact solid-plate
![[Salome Meca Tutorial] How to simulate a contact solid-plate](https://feaforall.com/wp-content/uploads/2018/03/plate-solid-contact-salome-meca-1024x576.jpg)
In a previous post a few days ago, I was showing t you how to simulate a glued contact between 2 solids. I realised that there were few nuances that I didn’t describe in that video when you needed to make a contact between a solid and a plate so I made another video to […]
[Salome Meca Tutorial] How to define a glued contact between parts
![[Salome Meca Tutorial] How to define a glued contact between parts](https://feaforall.com/wp-content/uploads/2018/03/contact-video-thumbnail-1024x576.jpg)
I am back for a new video about Salome Meca and Code_aster… this time about glued contact! If you want to perform an FEA simulation or a mechanical system, it only seems natural to have several parts in your analysis interacting together… Even if for test cases, you can use a simple plate model, real […]
