I finally got the time to finish this new Salome-Meca Tutorial that a lot of people asked me!
I hope you will like it :)
In this video you will learn:
- How to create a 2D axi-symmetric plate model in Geom
- How to mesh it with an arithmetic distribution gradient on one side
- How to perform a steady state thermal study with Code_Aster
- How to check the temperature and the thermal gradient in paravis
- How to create a new mechanical mesh set and project the thermal model on the mechanical model
- How to use the temperature field result of the thermal analysis as a thermal load in a mechanical analysis and how to calculate the thermal deformation
- How to check the results including stress in Paravis
If this is useful for you, please subscribe to my channel and give a like to the video!
Thank you so much
Check my other Salome-Meca Tutorials here:
Thank you so much for taking the time to develop that tutorial. I have a question related to a case I am studying right now, though. What if you had two concentric cylinders from different materials, with temperatures applied at the inner surface of the inner cylinder and at the outer surface of the outer cylinder, how would you model the thermal contact, the conductance across the small gap between the two cylinders? Note that the small gap and so the thermal conductance change during the solution due to the differential thermal expansions of the two cylinders, suggesting a direct field coupled analysis. Thanks again!
A good video. I learned a lot about static thermal model, but now I want to know something about Transient thermal model, could you tell me how to do. Thank you very much!!
I watched the video “Mechanical Analysis of a 2D Axisymmetric plate”, which is helpful to me. But I have a problem, In the Stage 3, when I assign a material, I could not find the PROJ CHAMP, even if I choose Yes in the Stage 2-Pre analysis. could you give me an answer. I will appreciate it.
Just save your project, then close Salome-Meca and re-open it and try again. I think that’s a bug.
I solved it. Thank you.
Thanks for your video, which I studied how to use the Salome Meca from. Now, I have another problem: when I run the Stage3, it shows a bug (unexpected error. Type: RunnerError, Value:0). I do not know why. Could you give me some help? I will appreciate it.
Thank you very much, Cypiren, I have learned PROJ_CHAM from your videos. Now I’m considering whether I can project the stress field from mesh0 to mesh1. And in mesh1, I can use this this projected stress field to do some further calculations. Temperature field has been assigned to the new mesh successfully in you video. But I’m not sure I can assign this projected stress field to mesh1 too. When I assign material to mesh1, and tick the external field ( AFFE_VARC ), but I can’t find the keywords about stress in NOM_VARC.